đź“–
Cerulean Sonar Docs
Docs DirectoryStore
CeruleanTracker
CeruleanTracker
  • DEPRECATION NOTICE
  • Overview
    • Sensor Fusion
    • Input Devices
    • Output Messages
      • GPRMC message
      • GPDBT, GPHDT, GPGGA messages
      • Re-Broadcasting (“Re-Tweeting”) Topside GPS Messages
    • Typical Configuration
    • Operating CeruleanTracker
      • Input Device Status Panel
      • Status Detail Examples
      • Output Selection
      • Input Device Configuration Panels
        • Topside GPS Tab
        • ROVL Rx Tab
        • ROVL Command Window
        • ROVL Channels
        • DVL Tab
        • DVL Command Window
  • Installing Firmware
    • Finding Firmware Files
    • ROVL Firmware Files by Device Type
    • Updating Firmware in a Functioning Device
    • Installing Firmware in a Bricked Device
    • Putting ROVL Devices into Hardware Bootloader Mode
    • Putting DVL Devices into Hardware Bootloader Mode
  • Installing DVL Firmware (Deprecated)
  • Installing ROVL Firmware (Deprecated)
  • CeruleanMap
    • Overview
    • Setting Up QGroundControl
    • Copyright
Powered by GitBook
On this page
  1. Overview
  2. Operating CeruleanTracker

Status Detail Examples

PreviousInput Device Status PanelNextOutput Selection

Last updated 1 year ago

Status Detail that corresponds to the Red status shown on the example main window. In this case, the root cause of the problem was the ROVL Receiver was sitting on my desk while I was writing the manual, thus: ROVL Tx not powered; neither device is in the water.
Status Detail that corresponds to the Yellow status shown on the example main window. In this case, the root cause was the DVL was sitting on my desk next to the ROVL Receiver.
Status Detail that corresponds to the Green status shown on the example main window.