📖
Cerulean Sonar Docs
Docs DirectoryStore
Omnitrack User Guide
Omnitrack User Guide
  • Omnitrack User Guide
  • Quick Start for BlueROV Users
    • Omnitrack Basic (Ring Buoy, Wired POE Tether, no BaseStation Plus)
    • Omnitrack Basic (Ring Buoy, Wi-Fi Connection, no BaseStation Plus)
  • System Startup (BlueROV)
    • ROV Startup
    • Tracker 650 Startup
    • ROV Locator Startup
  • Bench Testing and Simulation
    • ROVL Simulation
    • IMU Simulation
    • GNSS Compass Position Simulation
    • GNSS Compass Heading Simulation
  • Omnitrack Configurations
    • Canonical Configuration
    • Wi-Fi Configuration
    • ROV Locator (ROVL)
    • GNSS Compass
    • Power-over-Ethernet Communication
    • Tracker 650
    • Laptop
  • Standard Blue Robotics Ecosystem Internet Protocol (IP) Addresses
  • Topside ROV Locator Floatation and Mounting Options
    • Ring Buoy
    • BlueBoat
    • Blue Buoy
    • User-Supplied Float and Rigid Mount
  • Interface Connection Options for the Topside ROV Locator in an Omnitrack System
    • Interface via a BlueBoat
    • Interface via POE cable
    • Wi-Fi Module
  • GNSS Compass Mounting Dimensions
  • BaseStation Plus
    • Setting Up the BaseStation Plus
  • Bridging the BlueROV Network and the Omnitrack Network
  • Installing an Ethernet Switch in a BlueROV Topside Tether Interface
    • Overview
    • The Tether Ethernet Switch and Cable
    • Connecting to the Tether Network
    • Connecting to the Tether Interface Power
    • Re-Assembly
  • Omnitrack Assembly Instructions
    • General -- Applies to All Assemblies
    • BlueBoat/BlueBuoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Install Lanyards
      • Adjust Breakaway Latch
    • Ring Buoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Assemble the System
    • Attach the Electronics
    • Prepare Wiring Harness
  • Hints and Tips
  • Copyright
Powered by GitBook
On this page
  1. Bench Testing and Simulation

GNSS Compass Heading Simulation

PreviousGNSS Compass Position SimulationNextOmnitrack Configurations

Last updated 2 months ago

The GNSS heading simulation provides a stable and repeatable way to give the system a GNSS compass heading fix at a given orientation.

The GNSS compass heading is overridden by the IMU simulation yaw. You need to turn off IMU simulation to see the effect of GNSS compass heading.

The heading entered in the simulation is before any mounting offset is applied.