📖
Cerulean Sonar Docs
Docs DirectoryStore
CeruleanTracker
CeruleanTracker
  • DEPRECATION NOTICE
  • Overview
    • Sensor Fusion
    • Input Devices
    • Output Messages
      • GPRMC message
      • GPDBT, GPHDT, GPGGA messages
      • Re-Broadcasting (“Re-Tweeting”) Topside GPS Messages
    • Typical Configuration
    • Operating CeruleanTracker
      • Input Device Status Panel
      • Status Detail Examples
      • Output Selection
      • Input Device Configuration Panels
        • Topside GPS Tab
        • ROVL Rx Tab
        • ROVL Command Window
        • ROVL Channels
        • DVL Tab
        • DVL Command Window
  • Installing Firmware
    • Finding Firmware Files
    • ROVL Firmware Files by Device Type
    • Updating Firmware in a Functioning Device
    • Installing Firmware in a Bricked Device
    • Putting ROVL Devices into Hardware Bootloader Mode
    • Putting DVL Devices into Hardware Bootloader Mode
  • Installing DVL Firmware (Deprecated)
  • Installing ROVL Firmware (Deprecated)
  • CeruleanMap
    • Overview
    • Setting Up QGroundControl
    • Copyright
Powered by GitBook
On this page
  1. Overview
  2. Output Messages

Re-Broadcasting (“Re-Tweeting”) Topside GPS Messages

PreviousGPDBT, GPHDT, GPGGA messagesNextTypical Configuration

Last updated 1 year ago

CeruleanTracker can re-broadcast the topside GPS messages to a specific or broadcast IP address. The default is not to re-broadcast GPS messages. The configurable IP address field is pre-populated to send to port 14401 via the IP standard broadcast address, which is compatible with QGroundControl (see also ).

this