📖
Cerulean Sonar Docs
Docs DirectoryStore
Omnitrack User Guide
Omnitrack User Guide
  • Omnitrack User Guide
  • Quick Start for BlueROV Users
    • Omnitrack Base System with Tether
    • Omnitrack Base System with Wi-Fi
  • Omnitrack Configurations
    • Base System with Tether
    • Base System with Wi-Fi
    • Enhanced System with BaseStation Plus
    • ROV Locator (ROVL)
    • GNSS Compass
    • Power-over-Ethernet Communication
    • Tracker 650
    • Laptop
    • Wi-Fi
  • System Startup (BlueROV)
    • ROV Startup
    • Tracker 650 Startup
    • ROV Locator Startup
  • Standard Blue Robotics Ecosystem Internet Protocol (IP) Addresses
  • Topside ROV Locator Floatation and Mounting Options
    • Ring Buoy
    • BlueBoat
    • Blue Buoy
    • User-Supplied Float and Rigid Mount
  • Interface Connection Options for the Topside ROV Locator in an Omnitrack System
    • Interface via Tether (POE cable)
    • Interface via a BlueBoat
    • Wi-Fi Module
  • Wi-Fi Module System
    • Choosing Wi-Fi Radio Configurations
    • Configuring the Wi-Fi Radios
    • Configuring Country and Antenna Gain Settings
  • GNSS Compass Mounting Dimensions
  • Setting Up your Computer for Wired (Power-Over-Ethernet) Connection
  • BaseStation Plus
    • Setting Up the BaseStation Plus for Omnitrack (without BlueBoat)
    • Setting Up the BaseStation Plus for Omnitrack (with BlueBoat)
    • Setting Up the BaseStation Plus -- All Versions
  • Bridging the BlueROV Network and the Omnitrack Network
  • Installing an Ethernet Switch in a BlueROV Topside Tether Interface
    • Overview
    • The Tether Ethernet Switch and Cable
    • Connecting to the Tether Network
    • Connecting to the Tether Interface Power
    • Re-Assembly
  • Omnitrack Assembly Instructions
    • General -- Applies to All Assemblies
    • BlueBoat/BlueBuoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Install Lanyards
      • Adjust Breakaway Latch
    • Ring Buoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Assemble the System
    • Attach the Electronics
    • Prepare Wiring Harness
  • Bench Testing and Simulation
    • ROVL Simulation
    • IMU Simulation
    • GNSS Compass Position Simulation
    • GNSS Compass Heading Simulation
  • Hints and Tips
  • Copyright
Powered by GitBook
On this page

Interface Connection Options for the Topside ROV Locator in an Omnitrack System

The Omnitrack system is designed to be flexible to fit into user systems without much disruption. There are two interface points between Omnitrack components and user systems:

  • The ROVL transponder / transmitter on the ROV

  • The ROVL transceiver / receiver to the ROV's tether network

The ROVL transponder / transmitter is well-defined and has only one practical option, so we will focus here on the topside.

The key requirements are:

  • You must provide power to the ROVL

  • You must get Omnitrack data to and from the ROV via its tether network capability.

There are multiple ways to achieve this, and we will list the most practical ones in the following subsections.

PreviousUser-Supplied Float and Rigid MountNextInterface via Tether (POE cable)

Last updated 2 months ago