📖
Cerulean Sonar Docs
Docs DirectoryStore
Omnitrack User Guide
Omnitrack User Guide
  • Omnitrack User Guide
  • Quick Start for BlueROV Users
    • Omnitrack Base System with Tether
    • Omnitrack Base System with Wi-Fi
  • Omnitrack Configurations
    • Base System with Tether
    • Base System with Wi-Fi
    • Enhanced System with BaseStation Plus
    • ROV Locator (ROVL)
    • GNSS Compass
    • Power-over-Ethernet Communication
    • Tracker 650
    • Laptop
    • Wi-Fi
  • System Startup (BlueROV)
    • ROV Startup
    • Tracker 650 Startup
    • ROV Locator Startup
  • Standard Blue Robotics Ecosystem Internet Protocol (IP) Addresses
  • Topside ROV Locator Floatation and Mounting Options
    • Ring Buoy
    • BlueBoat
    • Blue Buoy
    • User-Supplied Float and Rigid Mount
  • Interface Connection Options for the Topside ROV Locator in an Omnitrack System
    • Interface via Tether (POE cable)
    • Interface via a BlueBoat
    • Wi-Fi Module
  • Wi-Fi Module System
    • Choosing Wi-Fi Radio Configurations
    • Configuring the Wi-Fi Radios
    • Configuring Country and Antenna Gain Settings
  • GNSS Compass Mounting Dimensions
  • Setting Up your Computer for Wired (Power-Over-Ethernet) Connection
  • BaseStation Plus
    • Setting Up the BaseStation Plus for Omnitrack (without BlueBoat)
    • Setting Up the BaseStation Plus for Omnitrack (with BlueBoat)
    • Setting Up the BaseStation Plus -- All Versions
  • Bridging the BlueROV Network and the Omnitrack Network
  • Installing an Ethernet Switch in a BlueROV Topside Tether Interface
    • Overview
    • The Tether Ethernet Switch and Cable
    • Connecting to the Tether Network
    • Connecting to the Tether Interface Power
    • Re-Assembly
  • Omnitrack Assembly Instructions
    • General -- Applies to All Assemblies
    • BlueBoat/BlueBuoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Install Lanyards
      • Adjust Breakaway Latch
    • Ring Buoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Assemble the System
    • Attach the Electronics
    • Prepare Wiring Harness
  • Bench Testing and Simulation
    • ROVL Simulation
    • IMU Simulation
    • GNSS Compass Position Simulation
    • GNSS Compass Heading Simulation
  • Hints and Tips
  • Copyright
Powered by GitBook
On this page
  1. Interface Connection Options for the Topside ROV Locator in an Omnitrack System

Interface via a BlueBoat

PreviousInterface via Tether (POE cable)NextWi-Fi Module

Last updated 2 months ago

If you mount the Omnitrack system on BlueBoat, you can order a wiring harness that connects to the BlueBoat battery for power, and the BlueBoat Ethernet switch to get Omnitrack data onto the BlueBoat's wireless connection to the operator.

In this scenario you need the RED cables. Note some system components not shown for clarity.

You will need to make a connection between the BlueBoat BaseStation network and the ROV network at the topside.