📖
Cerulean Sonar Docs
Docs DirectoryStore
Omnitrack User Guide
Omnitrack User Guide
  • Omnitrack User Guide
  • Quick Start for BlueROV Users
    • Omnitrack Base System with Tether
    • Omnitrack Base System with Wi-Fi
  • Omnitrack Configurations
    • Base System with Tether
    • Base System with Wi-Fi
    • Enhanced System with BaseStation Plus
    • ROV Locator (ROVL)
    • GNSS Compass
    • Power-over-Ethernet Communication
    • Tracker 650
    • Laptop
    • Wi-Fi
  • System Startup (BlueROV)
    • ROV Startup
    • Tracker 650 Startup
    • ROV Locator Startup
  • Standard Blue Robotics Ecosystem Internet Protocol (IP) Addresses
  • Topside ROV Locator Floatation and Mounting Options
    • Ring Buoy
    • BlueBoat
    • Blue Buoy
    • User-Supplied Float and Rigid Mount
  • Interface Connection Options for the Topside ROV Locator in an Omnitrack System
    • Interface via Tether (POE cable)
    • Interface via a BlueBoat
    • Wi-Fi Module
  • Wi-Fi Module System
    • Choosing Wi-Fi Radio Configurations
    • Configuring the Wi-Fi Radios
    • Configuring Country and Antenna Gain Settings
  • GNSS Compass Mounting Dimensions
  • Setting Up your Computer for Wired (Power-Over-Ethernet) Connection
  • BaseStation Plus
    • Setting Up the BaseStation Plus for Omnitrack (without BlueBoat)
    • Setting Up the BaseStation Plus for Omnitrack (with BlueBoat)
    • Setting Up the BaseStation Plus -- All Versions
  • Bridging the BlueROV Network and the Omnitrack Network
  • Installing an Ethernet Switch in a BlueROV Topside Tether Interface
    • Overview
    • The Tether Ethernet Switch and Cable
    • Connecting to the Tether Network
    • Connecting to the Tether Interface Power
    • Re-Assembly
  • Omnitrack Assembly Instructions
    • General -- Applies to All Assemblies
    • BlueBoat/BlueBuoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Install Lanyards
      • Adjust Breakaway Latch
    • Ring Buoy Assembly
      • Identify Parts
      • Assemble the Sting
      • Assemble the GNSS Crossbar
      • Install Mounting Hardware
      • Assemble the System
    • Attach the Electronics
    • Prepare Wiring Harness
  • Bench Testing and Simulation
    • ROVL Simulation
    • IMU Simulation
    • GNSS Compass Position Simulation
    • GNSS Compass Heading Simulation
  • Hints and Tips
  • Copyright
Powered by GitBook
On this page
  1. Omnitrack Assembly Instructions

Ring Buoy Assembly

PreviousAdjust Breakaway LatchNextIdentify Parts

Last updated 1 month ago

The images below show the fully-assembled system with the optional Wi-Fi module attached. You might use a wired POE tether instead of Wi-Fi.

Systems below are shown without wiring for clarity.

Note: an inexpensive bicycle stand can be helpful to hold the system while you are assembling it.

Ring Buoy seen from "starboard" side.
Ring Buoy seen from "stern" side.
Ring Buoy seen from top side.
Ring Buoy seen broken down for transport.