Commands Accepted by the Tracker 650

Here is a summary table of commands the Tracker 650 recognizes. Each message is described in further detail after the table. “Sticky” means the effect of the command is preserved across a power on/off cycle. Commands are terminated with a newline (ASCII 0x0A, C++ “\n”). Carriage returns (ASCII 0x0D, C++ “\r”), if any, prior to the newline are ignored. There are additional commands for factory use that are not documented. Try not to experiment, for example, we recommend not sending a “BRICK-DEVICE” command to see what will happen.

Command

Serial

Ethernet

Sticky*

Notes

X

X

Send the current system configuration

X

X

X

Turn on/off auto MAVlink origin message

X

X

X

Sets the speed of sound in the body of water where operating

X

X

X

Set a global adjustment to measured velocity

X

X

X

Turns Pool operating mode on and off.

X

X

X

Turn on/off position delta messages

X

X

X

Turn on/off extended position delta messages

X

X

X

Turn on/off $DVKFC message

X

X

X

Enables send the MAVlink distance message if the MAVlink interface is enabled.

X

X

Passes the supplied position to the MAVlink interface if it is enabled.

X

X

X

Sets the mounting orientation of the DVL sensor with respect to the ROV coordinate frame

X

X

X

Set/delete a static IP address for the Tracker 650

X

X

X

Set an IP address for the host

X

X

X

Set an IP address and port for the the MAVlink REST server. Setting the IP address to 0.0.0.0 will disable the MAVlink interface.

X

X

X

Set a fallback IP address for the Tracker 650

X

Change broadcast to unicast

X

X

Suspends pinging and processing

X

X

Resumes pinging and processing

X

X

Restart the Tracker 650 as if powered up

X

Blue Robotics Ethernet Discovery

(ARP)

X

Ethernet Address Resolution Protocol

X

Ethernet Dynamic Host Configuration Protocol

X

Ethernet Internet Control Message Protocol Ping

Last updated