Assemble the Sting

Install spring bushings inside the channel of the sting in the locations noted.

Install latch-sting-a and the larger piece of latch-sting-mech using (2) M5x60mm bolts. The latch-sting-a has two nubs that will snap into the 6mm hole nearest the pivot (left-most 6mm hole in the image above). The image below shows the final assemby in place. Note the open side of the U-channel in relation to latch-sting-a.

Using a m6x60 bolt, install rovl-tube-grip on the end of the sting with the spring-round-bushing. Note rovl-tube-grip is keyed so it can only install one way. Do not install the ROVL yet.

Set the Sting aside for now.